Steps And Precautions For Car Waxing

Of course, the car must be washed before waxing. For cars that need to be waxed, it is best to thoroughly clean the car body with car wash liquid, and then wipe the water dry. Before waxing, check the car body to make sure there is no dust;

Use a special sponge dipped in wax, and apply it evenly on the surface of the car paint in a circular motion. The area of ​​each application should not be too large, just half a meter square, and proceed piece by piece along the body of the car body. When applying wax, should I apply it in a circle or in a straight line? I specifically asked the master of the car beauty shop. He said that applying the wax in a circle not only applies it evenly, but also allows the car wax to penetrate deeply into the tiny depressions on the paint surface. place to prevent moisture from adhering to the surface of the car body to achieve the purpose of rust prevention. Of course, you can use any method, it is completely based on personal preference;

When the wax is in a solidified state, use a special towel to polish it in a straight line, alternating horizontal and vertical lines, and then follow the last step in the direction of rainwater flow. Remember not to polish in circles, as this can easily create a concentric halo effect on the surface of the car paint;

During the waxing process, it is inevitable that some car wax will remain in the gaps such as car lights, license plates, and doors. This will not only affect the appearance, but may also cause rust if left for a long time. Therefore, after waxing, the entire vehicle must be thoroughly cleaned. Wax the car in a cool place to ensure that the car body does not heat up. Because as the temperature rises, the adhesion of car wax becomes worse, which will affect the quality of waxing, so the best time to wax is on cloudy days or in the morning and evening. It is not advisable to wax a car that has just been driven. You should wait until the engine Let the hood cool before waxing. Waxing should follow the principle of going up first and then down, starting with the roof, then the hood, trunk lid, front and rear fenders, doors, etc.; when waxing, the sponge should not be too dry or too wet, just slightly dry. Please use the appropriate amount of wax. Don't think that using more wax will give you the best effect. This will be self-defeating;

If you find that the wax has dried while polishing, spray a little water on it before wiping it off. If the wax dries and you continue to wipe it hard, not only will the car not be bright, but the paint may be scratched due to friction; if spots appear, that is, when you carefully observe the paint surface against the light, if there are uneven shades, you can use a wet towel to wipe it lightly. Then polish. You can also ignore it and it will disappear naturally after washing the car.